Hey its Wes and welcome to Dinklife
As swimming season approached, I decided it was time to get our pool heater ready for another summer. One of the most important maintenance tasks I performed each year was inspecting the heater for nests, debris, and anything that could block airflow. In the past, small animals had made themselves at home inside the unit during the winter, which could lead to overheating and damaged components if left unchecked.
I started by removing the top cover and inspecting the inside of the heater. Fortunately, there were no nests this year, but there were still leaves and debris that needed to be cleaned out. Using a shop vacuum, I carefully cleaned the interior and made sure everything looked clear and ready for operation.
Once the heater was cleaned, I accessed the gas controls and turned the gas back on at the unit. After reassembling the heater, I headed into the basement to open the main gas valve and reconnect power. These simple steps helped ensure the heater would be ready to start after sitting idle all winter long.
With everything connected, I powered on the heater and increased the temperature setting until the ignition cycle began. It took several attempts for the burners to light because the gas lines had been empty, but eventually everything fired up properly. After letting the heater run and verifying normal operation, it was officially ready for summer. Remember, as always, whatever you decide to do, just get out there and do it!
Video: